- CL21 Polyester Film Capacitor
- 225J 250V Film Capacitor
- Package: Bulk and Tape
- Operating temperature: -55°C to 105°C
- Can withstand 200 times of destructive charge and discharge
Buy Cl21 Film Capacitor 225J 250V For LED Lighting
Description
Buy Cl21 Film Capacitor 225J 250V For LED Lighting
Buy Cl21 Film Capacitor 225J 250V refers to a capacitor that uses a plastic film as an electrolyte. Compared with ceramic and electrolytic capacitors, it has the advantages of good frequency characteristics, low dielectric loss and high reliability. The most widely used is polyester film media.
Characteristic of 225J 250V Film Capacitor
| ltem | Characteristics |
|---|---|
| Reference standard | GB7332 (IEC 60384-2) |
| Climatic Category | 40/85/21 |
| Rated Voltage | 250V |
| Capacitance | 2200nf |
| Capacitance Tolerance | ±5%(J) |
| Voltage proof | 1.6UR (2S) |
| Dissipation Factor | ≤0.01 (20°C, 1KHz) |
| Insulation Resistance
≥2500S |
20°C，1min |
Size of CL21 225J 250V Film Capacitor
CL21 225J 250V Film Capacitor
W: 32.0mm
H: 19.0mm
T:9.0mm
P±1: 27.5mm
FAQ
Q:Film capacitors have been wave soldered, lead-free soldered, about 200 degrees? High temperature can easily damage the capacitor or affect the life. Don’t know how this industry is controlled and handled? Is manual welding required? Is there a temperature limit in the capacitor specifications? Is the solder joint temperature or body temperature when labeling?
A：Hello, the temperature of the wave soldering peak of the film capacitor can be 275 ° C, which is also the temperature of the IEC standard, and the tin immersion time is 3S-5S. The other is the preheating temperature and time. Film capacitors can withstand this temperature. Does not affect electrical characteristics. The solderability temperature and soldering heat resistance temperature are stated in the specification approval book. The former is aimed at the solderability of capacitor pins, while the latter is about the influence of welding temperature on the characteristics of film capacitors.
Q: How to judge the quality of the film capacitor?
A: 1) Use a multimeter to test the resistance of the thin-film electricity. The two feet should be very high resistance. If there is a capacitance meter, measure whether the capacitance value matches the mark on the case.
2) Test performance at room temperature, including capacity, loss, insulation resistance, withstand voltage, ESR, etc.
3) Do simulated life test.
Contact Us
Email: filmcap@xuanxcapaciors.com
Ph/(whatsapp): +86-18825879082
Skype: Coco.PSH
Website: xuanxcapacitors.com
